How do I measure my air filter size?

3 min read · Updated October 2026

Short answer

Read the three numbers printed on the edge of your old filter, like 20×25×1: that is the nominal size you order by. If the printing is gone, measure width, height and depth with a tape and round each one up to the nearest inch.

Nominal vs actual size

Every filter has two sizes. The nominal size is the rounded, easy-to-say number printed on the cardboard frame, like 16×25×1. The actual size is the real, slightly smaller measurement, closer to 15½×24½×¾, so the filter slides into the slot without jamming.

You almost always order by the nominal size. We confirm the fit before you pick it up, so there’s no guessing.

The one rule to remember

Order by the nominal (rounded) size printed on your old filter. If you only have a tape measure, round each dimension up to the nearest inch.

Find your size in 3 steps

  1. Pull your old filter. Slide it out of the return vent or the slot next to your air handler or furnace. Note which way the airflow arrow points before it comes out.
  2. Read the printed size. Look along the cardboard edge for three numbers like 20×20×1. That’s width, height and depth in inches: your nominal size.
  3. No printing? Measure and round up. Measure width, height and depth with a tape, then round each up to the nearest whole inch. A filter measuring 19½×19½×¾ is a 20×20×1.

What if the printing has worn off?

Humidity and handling can rub the size right off the frame. If you can’t read it:

  • Measure the old filter itself (not the slot) and round up.
  • Check your air handler’s manual or the sticker inside the access panel.
  • Snap a photo and bring it into our Stuart store. We’ll match it on the spot.

Standard vs custom sizes

Most homes use one of a few dozen standard sizes, and we keep the common ones on the shelf. See the sizes we stock. Older homes and oversized returns sometimes need an odd size. We cut those to your exact dimensions in 1 to 2 days.

Know your size?

Tell us the size and MERV and we'll have it ready for pickup in Stuart.

Common questions

What is the difference between nominal and actual size?

The nominal size is the rounded number printed on the frame, like 20×25×1. The actual size is about half an inch smaller so the filter slides in cleanly. Order by the nominal size.

Should I measure the filter or the slot?

Measure the old filter and round up. If there is no filter to measure, measure the slot and tell us that is what you measured, and we will size it to fit.

Does the order of the numbers matter?

Not for width and height: 20×25×1 and 25×20×1 are the same filter. Depth is the smallest number, usually listed last.

Can you make a size that is not standard?

Yes. We cut custom and exact sizes in 1 to 2 days. Send the three numbers with the size request form.